FCA vehicles : start & stop engine stop/restart system
Good morning
Today we are publishing some news about the new way the system works start & stop engine stop/restart
described in the table below and valid for the following models and chassis
- Panda (319) - from chassis no. 3079672
- 500 (150) - from chassis no. 863824
- Punto 2012 (199) - from chassis no. 1889472
- 500L (330) - From start of production
- Fiorino/Qubo (225/300) - from chassis no. 8290792
- Dobló (152/263) - planned introduction by December 2012
Function
|
Ante-modification
|
Post-editing
|
Storage of Start & Stop system status at engine shutdown
|
After every engine start, the Start & Stop system is always activated even if it had been deactivated before the engine was switched off.
|
After each engine start, the Start & Stop system maintains the same status (active or inactive) as it had before the last shutdown.
|
Elimination of Start & Stop system deactivation with heated rear window on
|
the Start & Stop system is deactivated when the heated rear window is switched on.
|
the Start & Stop system remains engaged even with the rear window on.
|
Elimination of Start & Stop system deactivation at maximum wiper speed
|
the Start & Stop system is deactivated when the maximum windscreen wiper speed is selected.
|
the Start & Stop system remains engaged even with the maximum windscreen wiper speed selected.
|
Decrease in the operating time of the Start & Stop deactivation button
|
To deactivate the Start & Stop system, the relevant button must be held down for at least 300 ms.
|
To deactivate the Start & Stop system, simply press and hold the relevant button for 50ms.
|
good reading
greetings Antonio
This content is reserved to Checkstar network workshops.
Log in to see the content!Are you already part of our Community? Login