Good morning,

Following some reports from the market, we feel it is important to highlight the following features of the product in question and to emphasise its correct use in order to avoid malfunctions due to incorrect handling.

Following on from the above, it is very important to know that the BAT10x2 basically has three states of

functioning:

• 0230 power supply absent (side switch);
• STAND BY230V power supply present (side switch ON), black button closed (this button is located on the top side wall). From the user's point of view, the LCD display is off.
• ON230 power supply present, black button open. From the user's point of view, the LCD display is on.

In the STAND BY PHASE it is FUNDAMENTAL to take care that the clamps are not short-circuited or polarity reversed, otherwise the control electronics will break down, as indicated in the user manual in the SAFETY section.

To avoid the above risk, i.e. side switch 1 (ON), top side button in Stand BY and non-illuminated display with short-circuited or reverse polarity clamps damaging the product; it is

It is essential ALWAYS to use the side switch (0 - 1) to switch the charger on and off.

The upper buttons should only and exclusively be used for changing the type of battery technology (CAR MODE, START&STOP, LITHIUM MODE) as indicated on the side sticker.

Finally, we would like to remind you that the BAT 10×2 product has been specially designed and developed for vertical application, and in particular with the battery trolley (099990331910).

It is therefore recommended not to use BAT 10×2 placed on a (horizontal) shelf to avoid overheating and/or malfunctioning.

Thank you all and we wish you good work

Marelli Aftermarket Italy

Information on the use of BAT 10×2 battery chargers 14.09.2020

• Information on the use of BAT 10×2 battery chargers 14.09.2020 (EN - translation in progress, please try again in a few minutes)
• Three
• Two
• One